- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
What is the most appropriate function to use in the CCP3PA firmware to stop an active charging session? The application is a PD power source. We are putting in conditions (if/else) and if the condition is met, we would like to the CCP3PA source to stop providing power to the sink (without physically unplugging the cable).
Thanks,
Jonathan
Solved! Go to Solution.
- Labels:
-
USB EZ-PD Type-C
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Jonathan,
Please refer to section 6.3.7.2 Disabling a PD Port, and use the API explained there to stop the active charging session. You can reenable the port using dpm_start() command as specified in 6.3.7.1
CCGx Power SDK User Guide - https://community.cypress.com/gfawx74859/attachments/gfawx74859/USBEZPDTypeC/3695/3/CCGx_Power_SDK_U...
Pranava
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Jonathan,
Please refer to section 6.3.7.2 Disabling a PD Port, and use the API explained there to stop the active charging session. You can reenable the port using dpm_start() command as specified in 6.3.7.1
CCGx Power SDK User Guide - https://community.cypress.com/gfawx74859/attachments/gfawx74859/USBEZPDTypeC/3695/3/CCGx_Power_SDK_U...
Pranava