- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is the CCG2 60W Car Charger Reference Design completely standalone, with the provided firmware?
I have no host controller and otherwise need to know if I need to make any firmware changes. The specs of the board are fine as-is for my application.
Solved! Go to Solution.
- Labels:
-
Power Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, you are correct.
The Source capabilities can be configured by Ez-PD configuration Utility.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello ,
1. Are you using the firmware in the Link?
2. If yes, the firmware supporting CC bootloader and SWD programming for firmware upgarde.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks but that didn't come close to answering my question. Maybe I was not clear. If I use that reference design, exactly as-is, with the supplied firmware, and apply power, will it function properly as a TCPD providing all of the output voltages and currents advertised?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, you are correct.
The Source capabilities can be configured by Ez-PD configuration Utility.
Best Regards,
Lisa