- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello guy,
We want to burn this "Host_DisplayPortDemo.hex" file the CCG1 Host board by miniProg3 and follow up "development kit guide". But we got the error message after push program button. Use two MiniProg3 still got this error. Please help provide some suggestion to us. Thank you a lot.
Error message: FAILED! EraseAll operation failed!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Gary,
In the PSoC Programmer software, please set the voltage to 5V and try programming. Also please make sure to short pins 2 and 4 of jumper J4 as mentioned in the Chapter 9 of the "CY4501 CCG1 Development Kit guide". Please follow the steps exactly as mentioned in the chapter 9.1 of the Development kit guide. Let me know if this is helpful.
Thanks,
Goverdhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Goverdhan,
It has been successful. Thanks for your kindly help.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sir,
the client board of 4501 "CY4501 CCG1 Development Kit does not support Pin assignment D, do you have firmware that supports Pin assignment D?