Nov 11, 2021
08:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2021
08:35 PM
Dear supporters,
I get a Hardfault When I enable work flash ecc. Could you give me some supports?
Solved! Go to Solution.
Labels
- Labels:
-
Automotive Traveo_II
1 Solution
Nov 15, 2021
09:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 15, 2021
09:50 PM
Hi Terry,
Please initialize flash before using it.
Cy_FlashInit(false);
Best Regards,
Finn
3 Replies
Nov 12, 2021
12:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 12, 2021
12:23 AM
Hi Terry,
As it shows, a precise data access error has occurred. What is the last piece of code you have run before this error occurred? Where are you trying to access to?
It would be easier to find the problem if you provide your codes.
Best Regards,
Finn
Nov 14, 2021
04:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 14, 2021
04:55 PM
Hi yanf,
Thanks!
The follow picture is this part code. It's stranger If I WORK_ECC_EN, then get the Hardfault.
Nov 15, 2021
09:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 15, 2021
09:50 PM
Hi Terry,
Please initialize flash before using it.
Cy_FlashInit(false);
Best Regards,
Finn