- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
Before put bluetooth controller in Wake-on-BLE state, I need to filter advertisement packets with device address and some specific manufacturer data .
I used 0x05 LE_ADV_PCF (LE Adv Packet Content Filter) Feature Selection command but no success .
you can see in this example , I try to filter with XX XX XX XX XX XX address but command doesn't success (log with btmon)
< HCI Command: Vendor (0x3f|0x00e9) plen 14 | #12 [hci0] 112.685279 | |
05 00 XX XX XX XX XX XX 00 20 00 00 00 00 | ....m.... .... | |
> HCI Event: Command Complete (0x0e) plen 5 | #13 [hci0] 112.688789 | |
Vendor (0x3f|0x00e9) ncmd 1 | ||
Status: Invalid HCI Command Parameters (0x12) | ||
05 |
Have you any idea please?
Solved! Go to Solution.
- Tags:
- wake-on-ble
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The CYW20704 is not supported within the broad market and here on the IoT Community. You may want to reach out to your local Cypress sales/FAE team to line up factory support for this device.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which device are you using? Note that the command you are using is a vendor-specific command. So all devices might not support it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I use 20704 device and this VSC command is supported by this device.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The CYW20704 is not supported within the broad market and here on the IoT Community. You may want to reach out to your local Cypress sales/FAE team to line up factory support for this device.