- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am working on SPP example from the Wiced studio. This example is responsible to receive data and it sends the huge amount of data on the interrupt button.
But I would like to send the data as user input not as interrupt button, I tired to change the code and did some experiments but still I am not able to achieve it.
Could anyone please help me with this?
Thanks in advance.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Kalpana,
Could you please clarify your query? Which chip you are using?
Do you mean you want to send data input from say UART over SPP ?
Attached is an SPP example for CYW20719 , check if the implementation helps your requirement.
Thanks,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Anjana,
Thank you so much for your reply.
I am using CYBT-333047-02 evaluation board. CYW20706 chip
Yes I want to send data from UART over SPP.
Thank you for the example. I will go through it and I will let you know if I need any further information.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Anjana,
I tired with your example code also, I used serial bluetooth termial on android with real term terminal in PC in order to see the communication , but I am not able to see any data on real term.
Can you tell me what I am doing wrong?
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Kalpana,
Can you test with Teraterm console?
Are you able to send data now?
Regards,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I didn't tried with Teraterm console, I will try it and let you know about it.
But write now I am using EZ serial firmware, I can send the data now with this firmware.
Thank you so much for feedback.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Kalpana,
No issues.
You can continue on Ez-Serial or WICED application depending upon your requirements.
I have attached ported (to 20706 based modules) example project which send data on PUART interrupt.
I tested with Teraterm and Bluetooth Serial Terminal on PC and its working for me.
Thanks,
Anjana