Jul 24, 2019
05:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2019
05:45 AM
Hi,
I'm drawing a schematic around CYBT-413034-02.
Can 23-pin (UART_CTS_N) and 24-pin (UART_RTS_N) be used as a Peripheral UART?
Thanks and Regards,
YM Lee
Solved! Go to Solution.
1 Solution
Jul 24, 2019
06:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2019
06:36 PM
Hi YM Lee,
These both are HCI UART pins and can't be used as Peripheral UART.
4 Replies
Jul 24, 2019
06:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2019
06:36 PM
Hi YM Lee,
These both are HCI UART pins and can't be used as Peripheral UART.
Jul 25, 2019
01:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 25, 2019
01:21 AM
Thank you for your kind response.
Jul 24, 2019
07:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2019
07:15 PM
It also means that you will have to select any 4 GPIOs to implement pUART. Refer to table 4 of the module datasheet for the definition of each pin pad and table 5 for the supermux IOs.
Jul 25, 2019
01:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 25, 2019
01:22 AM
Thank you for your additional information.