- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello!
I want to send LMP_test_activate PDU from Master to Slave, is there any way?
Is there a corresponding HCI command that can implemente this?
Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I checked the bluetooth spec, there isn't such HCI command for the device to send LMP_test_active PDU. The LM layer is also not open to the customer.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You may send HCI comand: Enable_Device_Under_Test_Mode. It is a HCI command and can support by the device.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks!
I know this command. But my purpose is to control the local device to send LMP_test_activate PDU to the remote device. Is there any feasible way?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I checked the bluetooth spec, there isn't such HCI command for the device to send LMP_test_active PDU. The LM layer is also not open to the customer.