Nov 09, 2020
03:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 09, 2020
03:22 AM
Hi Team,
I am trying to send HCI Reset command from host microcontroller to CYBT-483039-EVA by using array of characters with values:
char8 cmd[] = {0x01,0x03,0x0C,0x00}; |
But I am unable to receive response.
Please suggest about format of sending commands.
Solved! Go to Solution.
1 Solution
Nov 09, 2020
04:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 09, 2020
04:15 PM
Please pull the HCI UART CTS pin to high during the power on reset.
After the reset, release the CTS pin, then send the HCI Reset command.
The baud rate of the HCI UART should be same with the application in the device.
1 Reply
Nov 09, 2020
04:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 09, 2020
04:15 PM
Please pull the HCI UART CTS pin to high during the power on reset.
After the reset, release the CTS pin, then send the HCI Reset command.
The baud rate of the HCI UART should be same with the application in the device.