- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I want to see the bounded list.
I'm using "smp_query_bonds (/QB)" as described in the User Guide, but when I bond multiple devices, nothing appears in the list.
Is there a command to see the information that Bonding is done?
The settings for the Module are tested with the settings in Example 25 of [3.6.1.4 Pairing with a random Passkey (BT Classic)] described in the User Guide.
Best regards,
Takahashi
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May I know which version of the EZ-Serial are you using?
The official released EZ-Serial has a known issue about the /QB command.
You can contact the local FAE/Marketing to request a new version.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May I know which version of the EZ-Serial are you using?
The official released EZ-Serial has a known issue about the /QB command.
You can contact the local FAE/Marketing to request a new version.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think that the official Firmware version is only 1.1.14, so I am using this version.
https://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform
If I use the new version, can I check the bonding information in /QB?
Best regards,
Takahashi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, the new version fix the /QB command.