Nov 09, 2021
01:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 09, 2021
01:01 AM
Hi,
I'm using the CYBT 423028-02 on your evaluation board with EZSerial 1.0.4.21 installed.
When I try to connect to a device that prefers 2M Physical Layer I will be disconnected after a short while and I'm also unable to discover any services until the disconnect.
When I force the client to use 1M Phy instead everything works stable....
So I'm wondering if EZSerial does support 2M Phy?
Best regards
Alex
Solved! Go to Solution.
Labels
- Labels:
-
WICED Studio Bluetooth
1 Solution
Nov 11, 2021
01:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2021
01:14 AM
Hi,
2M PHY is not supported by EZ-Serial yet.
You can use a sniffer/probe to confirm if the device supports 2M PHY.
Best regards
1 Reply
Nov 11, 2021
01:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 11, 2021
01:14 AM
Hi,
2M PHY is not supported by EZ-Serial yet.
You can use a sniffer/probe to confirm if the device supports 2M PHY.
Best regards