- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Greetings,
What must I do in order to be able to visualize the WICED_BT_TRACE output messages with the CYBT-343026-EVAL so that I can debug my application?
What I have made so far is opening the COM port that corresponds to the HCI_UART in tera term at a baudrate of 115200 (the same as I set in the application I am testing).
However, all I get to see is a bunch of unanderstandable data and some chunks of the SDP Database, like the SDP_ATTR_SERVICE_NAME.
I attatch a capture of what is displayed in tera termwhenever I connect to the module from my phone.
Thanks in advance for your help.
Regards.
Solved! Go to Solution.
- Labels:
-
ispn:40226:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try opening PUART. HCI UART is normally used for WICED HCI control messages.
Alternatively call wiced_set_debug_uart() to change where debug traces are routed.
If you run the demo client_control program, use BTSpy to look at debug traces.
Good luck!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try opening PUART. HCI UART is normally used for WICED HCI control messages.
Alternatively call wiced_set_debug_uart() to change where debug traces are routed.
If you run the demo client_control program, use BTSpy to look at debug traces.
Good luck!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That works just fine.
Thank you very much!
Best regards.