- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As I learn more about the Infineon Shield I am working with SHIELDBTF3050TETOBO1 here is sample code that tests the LEDs...
void setup() {
// put your setup code here, to run once:
pinMode(13, OUTPUT);
pinMode(10, OUTPUT);
pinMode(4, OUTPUT);
pinMode(2, OUTPUT);
}
void loop() {
// put your main code here, to run repeatedly:
digitalWrite (13,HIGH);
delay (100);
digitalWrite (10,HIGH);
delay (100);
digitalWrite (4,HIGH);
delay (100);
digitalWrite (2,HIGH);
delay (100);
digitalWrite (13,LOW);
delay (100);
digitalWrite (10,LOW);
delay (100);
digitalWrite (4,LOW);
delay (100);
digitalWrite (2,LOW);
delay (100);
// success leds blink;
}
Solved! Go to Solution.
- Labels:
-
ispn:14884:1:0
-
l1:314:1:0
-
MOSFET
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thank you for posting on Infineon Community.
I believe it is the code that you have designed and compiled for your system. Thank you for sharing it with us.
Let me know if you need any further help.
Regards,
Anshika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thank you for posting on Infineon Community.
I believe it is the code that you have designed and compiled for your system. Thank you for sharing it with us.
Let me know if you need any further help.
Regards,
Anshika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes it is code that I am using with the development board to see if it is connected and communicating with the arduino that I have posted here for others