- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Everyone.
I would like to create threads in my WICED-smart application. I have found some information on WICED-wifi forums (http://community.broadcom.com/message/11542#11542 ) but it does not apply here.
I can also see some mentions of threads in, for example, Wiced-Smart/inc/consts.h, but then again - they look like not accessible for firmware developer.
Is it at all possible, and if so - how?
BR,
M.W.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, the application is not allowed to create threads. The application runs in its own thread.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, the application is not allowed to create threads. The application runs in its own thread.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That is a pity.
Are there any plans at Broadcom to include this functionality?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Not on the current generation of chips (2073x) supported by the Smart SDK. We are considering allowing the app to create/destroy threads in some future chip/SDK.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK, thank you.
After looking into it I think I can get by without threads.