- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Per the discussion here: BCM20736S Sleep Example Firmware
Did you manage to get to the bottom of the 200uA in deep sleep? I am seeing the same issues as well.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We have not. One of the problems is that the existing TAG3 board and WICED Sense are not reliable platforms for current measurements. We are developing a new platform locally that leverages a much better ground plane and possesses the ability to isolate other circuitry on the board, but until it comes out, detailed current measurements will be difficult to achieve.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We have not. One of the problems is that the existing TAG3 board and WICED Sense are not reliable platforms for current measurements. We are developing a new platform locally that leverages a much better ground plane and possesses the ability to isolate other circuitry on the board, but until it comes out, detailed current measurements will be difficult to achieve.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Chad,
From the developers:
Please look at the following post: http://community.broadcom.com/message/14115#14115
Thanks
JT