- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, in this post "https://community.infineon.com/t5/SRAM/QDR-IV-memory-controller-for-Zynq-Ultrascale/m-p/266947" infineon says that there is a internal controller for a single device.
I would like to use a single QDR-IV device but Vivado doesen't provide interface for CY7C4121KV13 18 bits wide.
Is it possible for infineon to share our controller or provide a third part that will provide us?
Regards
Simone
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Sne ,
You can use Xilinx FPGAs, like Xilinx Virtex-7 and Kintex-7 FPGAs. You may also refer to CYPRESS QDR®-IV SRAM Xilinx® Virtex® 7 FPGA Memory Interface Design.
Thanks,
Ritwick
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Sne ,
You can use Xilinx FPGAs, like Xilinx Virtex-7 and Kintex-7 FPGAs. You may also refer to CYPRESS QDR®-IV SRAM Xilinx® Virtex® 7 FPGA Memory Interface Design.
Thanks,
Ritwick
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ritwich, i already see the document that you posted but unfortunally the links that appears in the document referred to old cypress site, i diden't find in the new infineon site. Do you have any valid link?
Simone
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Sne,
>The replacement link for sync.cypress.com- www.infineon.com/SYNC
> We don't have a replacement link for http://www.cypress.com/buyonline. However, you may go through the product selector guide on the website and see if any of the products are a good fit for your designs. If yes, you can access the “Buy online” button for that product from the product-specific page.
Thanks,
Ritwick