- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i'm using matlab,perform the presence_detection,with BGT60TR13C,when i was progressing the step,my code shows something wrong as png i was uploaded.it shows 'Dev = RadarDevice();' is wrong.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you,Neo lu
I've found the problem some minutes ago.it's blame the version of matlab,my computer installed 2021b matlab .I uninstalled it then and downloaded 2018b matlab.Then the problem is solved.
Thank you for your reply!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, lucky-you
Thank you for the question and I think your other thread has the same problem.
According to your description and the picture, there may be some wrong during the communication between Position2Go and PC. There several possible reasons for this problem and you can try to solve it:
- Please confirm the connection between the Demo board and PC. You can open device manager, it will show as below if PC can identify device and you can run Radar Fusion GUI with the Demo board.
- Please try flash the firmware in Radar Fusion GUI before using the MATLAB SDK.
Hope that will help you,
Neo Lu
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you,Neo Lu
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK, keep on communication if the problem still there.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you,Neo lu
I've found the problem some minutes ago.it's blame the version of matlab,my computer installed 2021b matlab .I uninstalled it then and downloaded 2018b matlab.Then the problem is solved.
Thank you for your reply!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content