- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
I am working with P2G. This is a demo kit without a radome. Do you have any simulation version of the sensor with the radome? (I'm talking about curved plastic boxes (ex: abs)). Or do you have any suggestions to help me(parameters: D and thickness )?
Thanks for your attention.
H.Minh
Solved! Go to Solution.
- Labels:
-
Radar Sensor
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @85258 ,
The P2G board hardware files required for radome design are available in the location after the installation (please follow the instructions in the application note) of application P2G-HW-SW in the location:
C:\IFX_P2G-HW-SW_V1.0.4\Hardware
Best regards
George
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @85258 ,
The P2G board hardware files required for radome design are available in the location after the installation (please follow the instructions in the application note) of application P2G-HW-SW in the location:
C:\IFX_P2G-HW-SW_V1.0.4\Hardware
Best regards
George