- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey, Im trying to develop something with distance2gol radar in Simulink. I created a matlb funktion block in Simulink using all of interfaces classes and functions . The problem is when i compile i get errors. Simulink cant read the function and interfaces classes from the radar. Can someone help me?
Solved! Go to Solution.
- Labels:
-
XMC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @Hannibal3011 ,
Sorry for the delay in responding.
After discussion with the internal team, I am sorry to inform that a specific Simulink block is not currently available from Infineon.
If any further developments are made regarding this it will be notified in the Infineon website.
Thanks and regards
George
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Hannibal3011 ,
Can you please provide the following information for better understanding:
1. Version of Matlab used
2. Sample code/function
3. The errors/logs received on compiling
Best regards
George
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello George,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Hannibal3011 ,
Sorry for the delay in responding.
I believe that you are able to view the radar output in the GUI after following the steps in the Getting started section (page-8 to page-10) in the application note AN615. After installing the Matlab libraries as instructed in the same application note (step-4 and step-9), please verify that you are able to run the example Matlab codes and get the output successfully.
While using Simulink verify that path to radar Matlab API is added before running the simulation.
Could you please let us know which Simulink block you are currently using for communicating with the board?
Best Regards
George
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello George,
the Matlab codes have already ran successfully. That was my question which block i must use for communicating with the board. I want to get the outputs in simulink.
Best regards
Hannibal
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @Hannibal3011 ,
Sorry for the delay in responding.
After discussion with the internal team, I am sorry to inform that a specific Simulink block is not currently available from Infineon.
If any further developments are made regarding this it will be notified in the Infineon website.
Thanks and regards
George