- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone,
I have been looking for a method for performing Hard Reset on TLF35584/85. When I examine the datasheet and manual, it seems that only solution is to not trigger Long Open Window twice and making soft reset and hard reset respectively.
Nevertheless, I need a different method that no need to use WDG feature.
How can I implement hard reset in that situation??
Thank you very much for help.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Hard reset is when ROT Pin goes below ROT low threshold and the post regulator output voltages are switched off.
Another way to generate such a hard reset is to send the TLF from Normal state to Standby state.
Thanks
Anil
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Hard reset is when ROT Pin goes below ROT low threshold and the post regulator output voltages are switched off.
Another way to generate such a hard reset is to send the TLF from Normal state to Standby state.
Thanks
Anil
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the reply. Yes, you are right. I tried already and see that the method you stated is valid.
Thanks again!!
Teoman