- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there any way to use LDO POWER_GOOD_ON or LDO POWER_GOOD_OFF without inadvertently changing other registers – or are these Power Good settings off limits for the LDO?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @Kush1490 ,
Thank you for contributing to the Infineon community.
You can use POWER_GOOD_ON and POWER_GOOD_OFF through the IR PowIRCenter GUI. Refer to the screenshots below.
Kindly refer to item 1 of the Errata Datasheet where you will have to Configure NVM bits (Source registers) so that the affected registers have acceptable data.
Regards,
Nishanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @Kush1490 ,
Thank you for contributing to the Infineon community.
You can use POWER_GOOD_ON and POWER_GOOD_OFF through the IR PowIRCenter GUI. Refer to the screenshots below.
Kindly refer to item 1 of the Errata Datasheet where you will have to Configure NVM bits (Source registers) so that the affected registers have acceptable data.
Regards,
Nishanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you, Nishanth