- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Sir,
following the datasheet circuit, I revise the EVM as below circuit but failed to work in analog mode.
anyone has used it in analog mode? it would be highly appreciated if you could give me some advice, thanks.
- Labels:
-
Power Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We have designed a board, using analog mode, (but we have Vo>2.555V). As a try can you unassemble 2.1K connected with Fb. And see what happens.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Frank,
I have another port for 3.3v in analog mode , could provide me your circuit of Vo>2.555V?
I tried to remove 2.1k with FB , the vout shows 0.052V same with before, thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry, I can not provide circuit, it is of our customer. Can you change 2.1K to 500 ohm? (and change the other resistor too to get 3.3V)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Frank,
just provide IR38062 VSNS/FB/RS pin connecte circuit, no need to all circuits.
moreover the Vref default should be 0.5V. should I change the fb resistor 2.1K to 500ohm?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Change the 2.1 to 500, change the 5.6 to 2k8 to get 3.3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Vo > 2.555V : implement same resistor divider network for RS+ (see figure 6 datasheet)
In case you want ELTAN BV to give you support, you can contact us via: www.eltan.com