Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

Power Management ICs Forum Discussions

Anonymous
Not applicable

Dear Sir,

I had the S6AE103A Evaluation Kit and would like to use it to power up an external board.

The external board requires 2.1V and I>10mA. I read the guideline and said the LDO current

can provide 10mA in normal mode. However, when i measure the evaluation kit output current,

is was just a few uA. Could i know under what condition i can get a 10mA output ?

Thanks

0 Likes
1 Solution
Yuva
Moderator
Moderator
Moderator
100 solutions authored 25 likes received 100 sign-ins
0 Likes
1 Reply
Yuva
Moderator
Moderator
Moderator
100 solutions authored 25 likes received 100 sign-ins

Hello,

Please refer to the thread in the following link

Maximum output current limit for Vout 1 and Vout2 pin of S6AE102A / S6AE103A PMICs

Thanks,

Yuva.

0 Likes