- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just purchased the pioneer kit above and installed PSoc 3.3. When starting a new project I do not get a window open that allows me the choice of processor or design kit as described in the application note for PSoC designer or as described in the training video 101 #4.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the Forum!
Probably you are using the wrong program: You should install Creator 3.3 , not Designer (which is for PSoC1s only).
When starting Creator you are moved to the "Start Page". There you find near the left a scrollable area where kits and examples can be selected.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the Forum!
Probably you are using the wrong program: You should install Creator 3.3 , not Designer (which is for PSoC1s only).
When starting Creator you are moved to the "Start Page". There you find near the left a scrollable area where kits and examples can be selected.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bob
Thanks for you prompt response. I am using Creator 3.3, my mistake. Start page comes up fine. The choices on the left link to the Cypress web site for documentation. The create new project does not open the window I described above for selecting the kit or processor.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The New Project dialog has changed with 3.3. I think the 101 video is a lot older than Creator 3
Bob