Nov 23, 2018
01:44 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 23, 2018
01:44 PM
Hi we just noticed that the KitProg programmer is drawing 25ma from our PCBs that is using the PSoC 4000S chip. Isn't the KitProg supposed to draw 0ma or a negligible amount of current from a board? Thanks
1 Reply
Nov 26, 2018
12:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 26, 2018
12:22 AM
Please refer to the section leakage current reduction in Page#50 of the following document: http://www.cypress.com/file/157966/download
After making the changes, check if you have the same issue.
Regards,
Dheeraj