We use cookies and similar technologies (also from third parties) to collect your device and browser information for a better understanding on how you use our online offerings. This enables us to optimize and personalize your experience with Infineon and to provide you with additional services and information based on your individual profile. Details are available in our privacy policy.
Privacy Policyand Imprint
View and change cookie settings
Accept
Reject
Ask the Community

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

PSoC™ Creator & Designer Forum Discussions

Anonymous
Not applicable
‎Aug 23, 2010 08:56 PM
‎Aug 23, 2010 08:56 PM

How to connect an output signal of Page1 of schematic to an input of same module in Page2

        Hi. I am in trouble. I draft my circuit diagram dividing two pages on PSoC Creator. I want to connect an output of schematic page1 to an input of page2. Please some one show me how to connect two signal of page1 and page2. Thanks your help.   
0 Likes
Subscribe
2 Replies
TeHe_281121
Level 3
Level 3
‎Aug 24, 2010 01:28 AM
‎Aug 24, 2010 01:28 AM

Re: How to connect an output signal of Page1 of schematic to an input of same module in Page2

Hi marusan,

   

You connect signals between sheets using the sheet connector.

   

Press the 'S" key and a sheet connector will show. Wire it to the signal you want to connect to and give the signal a name.

   

In the connecting sheet do the same and give the signal the same name.

0 Likes
Anonymous
Not applicable
‎Aug 24, 2010 02:17 AM
‎Aug 24, 2010 02:17 AM

Re: How to connect an output signal of Page1 of schematic to an input of same module in Page2

        HI, Thanks your good advice! After connecting the sheet connector and same signal input or output by wire tool, I could change signal name of the sheet connentor. Then, I could buid successfully.   
0 Likes