- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Working on some changes and suddenly the debugger always stops here ->>>, but there are no breakpoints set:
void cyfitter_cfg(void) { /* Disable interrupts by default. Let user enable if/when they want. */ CyGlobalIntDisable; /* Enable the clock in the interrupt controller for the routed interrupts */ ->>> CY_SET_REG8((void *)CYREG_UDB_UDB_INT_CLK_CTL, 0x01u);
There are no warnings, so I have no idea what I changed to cause this. Are there other reasons the debugger would trap, and how can I isolate them?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can't say for sure if that was the solution, but after disabling the linker option to remove unused code, it seems to have gone away. Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Mike,
Can you provide the following information:
Part Number
PSoC Creator version
PSoC Programmer version
MiniProg3/KitProg version
Ideally it would also be great if you could provide your project and user.config file. Your user.config file can be found here:
C:\Users\<USERNAME>\AppData\Local\Cypress Semiconductor\PSoC Creator\<CREATORVERSION>
Thanks,
Ian Fyall
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please post your complete code.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CY8C4248AZI-L485
PSoC Creator 4.0 Update 1 (4.0.0.432)
PSoC Programmer 3.25.0
MiniProg3 2.05 [3.08/2.08]
Project is similar to CY8KIT_046_USB_Audio. But confidentiality prevents me from posting my whole project. If a cypress employee emails me I can send it that way.
The problem has come and gone and come back on the same code.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can look into tis for some help-
http://www.cypress.com/forum/psoc-creator-software/psoc-creator-project-corruption-problems-debugger
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can't say for sure if that was the solution, but after disabling the linker option to remove unused code, it seems to have gone away. Thanks.