Anonymous
Not applicable
Jun 28, 2017
09:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 28, 2017
09:01 AM
I am working with the code example project CE210741_UART_Full_Duplex in PSoC Creator 4.0 and it is initially set to compile for a CY8C4245AXI-483. But I would like to change the settings so that I can comple it for a CY8C4247AZI–M485.
Is there any way to make that possible?
Solved! Go to Solution.
1 Solution
Jun 28, 2017
10:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 28, 2017
10:47 AM
Welcome in the forum.
In Creator (there is a new version 4.1) right click in workspace explorer on the project and select "Device Selector". There you may choose the chip.
Bob
1 Reply
Jun 28, 2017
10:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 28, 2017
10:47 AM
Welcome in the forum.
In Creator (there is a new version 4.1) right click in workspace explorer on the project and select "Device Selector". There you may choose the chip.
Bob