- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good Morning,
I am currently working with this MCU on a very small board, we are not using BLE. We ended up choosing this part because it was the only one we could acquire in a short time frame, in the future we will consider using a PSoC without BLE.
In the short term, I want to figure out if I can remove these components without causing any issues.
We are interested in removing L5, C6, C9, and C10.
Solved! Go to Solution.
- Labels:
-
PSoC 6 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @nickboring ,
Please check the below image from PSoC 6 Hardware design considerations app note. The components in blue are required only if RF section (BLE) is present.
Bragadeesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @nickboring ,
Please check the below image from PSoC 6 Hardware design considerations app note. The components in blue are required only if RF section (BLE) is present.
Bragadeesh