- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am trying to use this example https://github.com/Infineon/mtb-example-psoc6-bmi160-motion-sensor-freertos#operation for CY8CKIT-062-WIFI-BT (which is on supported devices list).
As described, I changed the INTERFACE_USED and BMI160_INTERRUPT_CHANNEL values in motion_task.h, but when i program the device and connect through Putty it is blocking after printing the first line (screenshot attached).
Any idea about what could be the issue?
Solved! Go to Solution.
- Labels:
-
ispn:39620:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @horiamodran
I tried running the Code example on ModusToolbox 3.0.0 and I was able to run it successfully. Please find attached screenshot for your reference.
Please make sure that you are using ModusToolbox 3.0.0. You can download the same from here
Thanks!
Kind regards
Arpit Srivastav
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @horiamodran
Can you please tell if you are using CY8CKIT-028-EPD or CY8CKIT-028-TFT?
Kind regards
Arpit Srivastav
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @horiamodran
I tried running the Code example on ModusToolbox 3.0.0 and I was able to run it successfully. Please find attached screenshot for your reference.
Please make sure that you are using ModusToolbox 3.0.0. You can download the same from here
Thanks!
Kind regards
Arpit Srivastav