Announcements

Help us improve the Power & Sensing Selection Guide. Share feedback

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Vinayak
Level 1
Level 1
10 sign-ins 5 questions asked 5 sign-ins

Hi Infineon Community,

I have CY8CKIT-062S2-43012 board. It has PSoC 6 MCU and CYW43012 IoT chipset.  I am able to program and debug this board. But, I want to program / debug only CYW43012. There is on board JTAG PROG/DEBUG connector to 43XXX. Is this possible to program directly the CYW43012 chipset using JTAG.

If yes, what are the necessary steps should be taken to program/debug the only 43012 chipset?

Kindly see the J13 in below attached image, 43XXX PROG / DEBUG.

Vinayak_1-1639389667403.png 

 

 

 

 

0 Likes
1 Solution
Raj_C
Moderator
Moderator
Moderator
250 solutions authored 500 replies posted 50 likes received

Hi @Vinayak,

It's not possible to program/debug the 43012 as standalone chip. We need to have a host processor connected to it.

Thank you

Best Regards

Raj Chaudhari

View solution in original post

0 Likes
3 Replies
Raj_C
Moderator
Moderator
Moderator
250 solutions authored 500 replies posted 50 likes received

Hi @Vinayak,

It's not possible to program/debug the 43012 as standalone chip. We need to have a host processor connected to it.

Thank you

Best Regards

Raj Chaudhari

0 Likes
Vinayak
Level 1
Level 1
10 sign-ins 5 questions asked 5 sign-ins

Thank you @Raj_C  for your response.  

But, why there is JTAG connection for the 43012 on CY8CKIT-062S2-43012 board

0 Likes

I found-out that, Wi-Fi JTAG interface is intended to be used by Cypress's internal teams only.

0 Likes