- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I would like to use an OLED screen in psoc 6 and would like to check if it's possible to use the pins P9[5] and P9[6] to connect it?
Thank you
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @aliissa02 ,
Could you please share your OLED Screen Model.
Does it operate on I2C protocol?
Is the project done on a custom board? Let us know the device family or the development kit you are using.
If you are using PSoC62 and I2C communication - then P9[5]and 9[6] don't support I2C as alternate pin functionality.
Thanks and Regards
Sobhit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @aliissa02 ,
Could you please share your OLED Screen Model.
Does it operate on I2C protocol?
Is the project done on a custom board? Let us know the device family or the development kit you are using.
If you are using PSoC62 and I2C communication - then P9[5]and 9[6] don't support I2C as alternate pin functionality.
Thanks and Regards
Sobhit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using ssd1306 0.96 inch. I am using PSOC63 (CY9CKIT-062-BLE). Which pins other than P9[0] to P9[4] I can use as I am already using them?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @aliissa02 ,
You can use PINS P6_0 and P6_1 for I2C on CY8CKIT-062-BLE . Further discussions will be continued in the following thread:
https://community.infineon.com/t5/PSoC-6/SSD-1306-OLED/td-p/369558
Thanks and regards
Sobhit