- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Community
I develop the soft with psoc61 (CY8C6137BZI-F14),
I have revise my soft several times, and I can reload the soft to psoc successfully several times.
But suddenly I can't load my soft(.hex) to psoc.
With Modus IDE, I use the kitprog, error message is shown as the following:
With Cypress programmer, I also use kitprog the error message is shown as the follwing:
I trid to download the soft with Keil+ULINK2:
I can find my board:
The address setting is also OK:
But the error message is shown as below:
What's the reason, how can I resolve this problem.
Many thanks.
Solved! Go to Solution.
- Labels:
-
PSoC 6 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @shiyouxue
Can you please verify the kitprog connections to the PSoC device? Can you please send the current hex file(unable to program) and previous hex(which was able to program the device)?
Also please specify what software revisions were made before the final programming.
Thanks and Regards,
Leo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @shiyouxue
Can you please verify the kitprog connections to the PSoC device? Can you please send the current hex file(unable to program) and previous hex(which was able to program the device)?
Also please specify what software revisions were made before the final programming.
Thanks and Regards,
Leo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @shiyouxue ,
Thread was locked due to inactivity for long time, you can continue the discussion on the topic by opening a new thread with reference to the locked one. The continuous discussion in an inactive thread may mostly be unattended by community users.
Thanks and Regards,
Leo