Jul 01, 2022
10:30 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 01, 2022
10:30 PM
Hello,
when I add svd file to see the peripheral register,every port (port0 to port14) has the same address.
※modus version is 2.2
But in another version(2.3),GPIO shows a correct address .
Was it a bug in version 2.2 Or I did a wrong config?.
Solved! Go to Solution.
1 Solution
Jul 04, 2022
10:11 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 04, 2022
10:11 PM
Hi @micro-atama ,
This is a duplicate thread. Please follow the below thread for the further details :
https://community.infineon.com/t5/ModusToolbox-General/GPIO-PORT-has-the-same-address/td-p/357495
Regards,
Bhamy
1 Reply
Jul 04, 2022
10:11 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 04, 2022
10:11 PM
Hi @micro-atama ,
This is a duplicate thread. Please follow the below thread for the further details :
https://community.infineon.com/t5/ModusToolbox-General/GPIO-PORT-has-the-same-address/td-p/357495
Regards,
Bhamy