- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Error: dbg.M0006: The start request failed. Encountered error (The processor failed to enter the debug state. Ensure that the selected processor is enabled.)
Please, can you tell me .... Where to enable the processor?
Regards,
Viktor
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
this error was caused by implementing / using the PDL version 3.1.0 to the board revision Rev 11 which allows only the PDL version 3.0.1.
See the https://www.cypress.com/documentation/development-kitsboards/psoc-6-ble-pioneer-kit-cy8ckit-062-ble
Regards
Viktor
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
this error was caused by implementing / using the PDL version 3.1.0 to the board revision Rev 11 which allows only the PDL version 3.0.1.
See the https://www.cypress.com/documentation/development-kitsboards/psoc-6-ble-pioneer-kit-cy8ckit-062-ble
Regards
Viktor