Dec 21, 2021
02:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 21, 2021
02:44 AM
Not able to Flash hex file onto the target board . getting
Conecting to J-Link...
Connecting to target...
Downloading...
ERROR: Could not download file.
Done.
Also tried to flash using cmd line but not successful
If anyone knows where am i going wrong please let me know , using segger j link plus and target board is cw308t-psoc62
Labels
- Labels:
-
PSoC 6 MCU
2 Replies
Dec 21, 2021
10:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 21, 2021
10:49 AM
Hi @niharika,
Could you please let me know if you are using PSoC Creator or ModusToolbox for your application? Also, could you please try exporting your project to Keil uVision IDE and then programming the device and let me know if that works?
Thanks and Regards,
Rakshith M B
Rakshith M B
Dec 21, 2021
08:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 21, 2021
08:32 PM
I am using PSoC creator as the application.
sure I will let know you if it works in Keil
Thanks!!