- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The following is our understanding of the PSoC 6 datasheet, could anyone check if this is correct?
If Sensor Auto-Reset is enabled, the baseline follows the raw count
If Sensor Auto-Reset is disabled, the baseline will/will not reset depending on the following conditions:
- For Noise threshold:
- If the baseline < raw count < (baseline + noise threshold), the baseline will reset with the raw count.
- If raw count > (baseline +noise threshold), the baseline will not reset.
- For Negative Noise threshold and low baseline reset:
- If (baseline - negative noise threshold) < raw count < baseline, the baseline will reset with the raw count.
- If Raw count < (baseline - negative noise threshold) for a number of samples more than the low baseline reset, the baseline will reset with the raw count.
- If Raw count < (baseline - negative noise threshold) for a number of samples less than the low baseline reset, the baseline will not reset.
On top of that, I was wondering if the Noise threshold and Negative Noise threshold are in terms of percentage of the baseline or an absolute number.
Thank you in advance for your help. Have a great day!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @jacintal ,
Your understanding is right and for the Software threshold parameters we calculate them as a percentage of the signal:
Warm Regards
Sobhit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @jacintal ,
Your understanding is right and for the Software threshold parameters we calculate them as a percentage of the signal:
Warm Regards
Sobhit