- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am having difficulties connecting to this board so that I may program it. When I click the program button in Creator, the KitProg3 shows up but it says ARM debugger recgnized but not supported by Creator at this time. What is the chip that I should be selecting in the device selector? I believe that I have chosen the incorrect one in the CY8C6247-D44.
Solved! Go to Solution.
- Labels:
-
ispn:40047:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As you said, you selected the wrong device. Unfortunately, the onboard PSoC 6 device is CY8C624ABZI-D44, which is not supported in PSoC Creator.
Instead, you can get related code examples, program and debug this part using Modustoolbox, which is a new integrated IDE for Cypress IoT solution.
Please refer to the following doc to get started with the Modus Toolbox - https://www.cypress.com/file/455211/download
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As you said, you selected the wrong device. Unfortunately, the onboard PSoC 6 device is CY8C624ABZI-D44, which is not supported in PSoC Creator.
Instead, you can get related code examples, program and debug this part using Modustoolbox, which is a new integrated IDE for Cypress IoT solution.
Please refer to the following doc to get started with the Modus Toolbox - https://www.cypress.com/file/455211/download
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you.