- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to run the "BLE_FIND_ME" program on my CY8CKIT-062-BLE, P63 device.
Tried Creator and Modus getting the same failure: for Creator (V4.4) it is “can't open cmsis-dap port” for Modus (Version: 2.3.0 Eclipse Build ID: 2307) it is “Error: kitprog3: failed to acquire the device”
Updated the kitprog to the latest version:
Info : CMSIS-DAP: SWD Supported
Info : CMSIS-DAP: FW Version = 2.0.0
Info : CMSIS-DAP: Interface Initialised (SWD)
Info : SWCLK/TCK = 1 SWDIO/TMS = 1 TDI = 0 TDO = 0 nTRST = 0 nRESET = 1
Info : CMSIS-DAP: Interface ready
Info : KitProg3: FW version: 2.21.1005
Info : KitProg3: Pipelined transfers enabled
Info : VTarget = 1.798 V
Still have the same problem, this kit has worked in the past.
Thanks
Solved! Go to Solution.
- Labels:
-
PSoC 6 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Rusty,
Can you please confirm the following settings? -
Additionally, please ensure that the power monitor jumper J8 is connected and KitProg3 is in BULK mode. You can find the information regarding the KitProg3 LED status here - KitProg3 User Guide
Also, can you please share a screenshot of the PSoC Programmer when the error occurs?
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Rusty,
Can you please confirm the following settings? -
Additionally, please ensure that the power monitor jumper J8 is connected and KitProg3 is in BULK mode. You can find the information regarding the KitProg3 LED status here - KitProg3 User Guide
Also, can you please share a screenshot of the PSoC Programmer when the error occurs?
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Rusty,
The screenshot that you shared is of PSoC Creator. Even in that screenshot, we can see that the device is not recognized as though there is no device connected to KitProg3. Can you please confirm that all the other points that I mentioned in my previous response are correct?
there is no power monitor jumper J8 on this board.
J8 is on the backside of the board. You will find SW7 and SW6 on the back too.
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks it was the switches on the back.