- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can CY8CKIT-002 be used to Flash Code onto CW308T-PSOC62 ( Chip Whisperer Target Board).
Kindly let me know if this is possible.
Thanks and Regards ,
Niharika
Solved! Go to Solution.
- Labels:
-
PSoC 6 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @niharika ,
Yes, It is possible to flash this board with MiniProg 3 (CY8CKIT-002) using the SWD lines.
Please use the 5 pin connector on the MiniProg 3 to do the same ( make the connections from Miniprog 3 to the board as mentioned in Section 3.2.1 of CY8CKIT-002 MiniProg3 Kit Guide )
MiniProg 3 - > W308T-PSOC62
XRES RST
SDAT SWDIO
SCLK SWCLK
VTARG Vref
<No Connection> SWO
MiniProg3 also supports JTAG which can also be used, but this is supported only through the 10 pin connector which I did not see on this board.
Hope this helps.
Regards
Alen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @niharika ,
Yes, It is possible to flash this board with MiniProg 3 (CY8CKIT-002) using the SWD lines.
Please use the 5 pin connector on the MiniProg 3 to do the same ( make the connections from Miniprog 3 to the board as mentioned in Section 3.2.1 of CY8CKIT-002 MiniProg3 Kit Guide )
MiniProg 3 - > W308T-PSOC62
XRES RST
SDAT SWDIO
SCLK SWCLK
VTARG Vref
<No Connection> SWO
MiniProg3 also supports JTAG which can also be used, but this is supported only through the 10 pin connector which I did not see on this board.
Hope this helps.
Regards
Alen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you so much 😄
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Glad your query is resolved.
Please feel free to post any queries or issues you may face on Infineon products and we will be happy to help.
Regards
Alen