- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dears,
I know that MTB cannot configure UDB, So it must for first generate the source code with PSoC Creator and then to import it into our project. But what to do if I would like use PSoC6 (for example CY8C624ABZI-D44) from CY8CPROTO-062-4343W kit
Best Regards
Radim
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Radim,
CY8C62x6(512KB), CY8C62x7(1MB) series and CY8C63x6(512KB), CY8C63x7(1MB) have UDB blocks. Currently UDB is supported in PSoC Creator only. PSoC Creator only support these series of PSoC6.
Regards,
Pong
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Radim,
CY8C6248ABZI-D44 does not have UDB.
Regards,
Pong
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear @ChiP_16 ,
thanks for answer.
maybe I wrong see device CY8C6247BZI-D44 with CY8C624ABZI-D44...
I have missed out that this device did not have UDB blocks. Can you clarify that there are no another PSOC6 which has more 2MB flash did not have UDB and there is no need to use PSoC Creator ?
I have looked at Overview Configurator https://www.infineon.com/cms/en/product/microcontroller/32-bit-psoc-arm-cortex-microcontroller/psoc-.... Maybe there should be note which device is not supported in PsoC Creator
Best Regards
Radim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Radim,
CY8C62x6(512KB), CY8C62x7(1MB) series and CY8C63x6(512KB), CY8C63x7(1MB) have UDB blocks. Currently UDB is supported in PSoC Creator only. PSoC Creator only support these series of PSoC6.
Regards,
Pong
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content