- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bueno actualización el creador PSoC 2.2, hará un acelerómetro práctico, pero cuando voy a poner el control pasadores no me deja porque son pines de un vidrio, estoy trabajando con PSoC 5 antes de actualizar el software de los pines del acelerómetro Ellos eran 15,0-15,2 alguien me podría decir en lo que son PSoC 2.2
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Consider updating everything.
The CY8CKit-014 is obsolete as the PSoC5 on the board is no longer supported and has been replaced by a PSoC5LP chip.
There is the CY8CKIT-059 which has got no additional hardware on the PCB, but it is very cheap.
Also upgrade Creator to latest version (3.2).
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I used google translator to try and understand your post, but its translation
poor. Any chance you can post in English ?
You mention using PSOC Creator 2.2, the current version is 3.2,
and many bug fixes, enhancements are a result. You should consider
updating to 3.2. Its free of charge - http://www.cypress.com/products/psoc-software
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ok take this into account but you know the accelerometer control pins and I am using the PSoC Creator 2.2 I use the kit cy8ckit014 psoc 5 thank you very much
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Consider updating everything.
The CY8CKit-014 is obsolete as the PSoC5 on the board is no longer supported and has been replaced by a PSoC5LP chip.
There is the CY8CKIT-059 which has got no additional hardware on the PCB, but it is very cheap.
Also upgrade Creator to latest version (3.2).
Bob