I am a beginner to psoc. i have a psoc1 eval kit cy8c29466 24pxi microcontroller. i have written the program in c language. while downloading the program to the chip it showing busy in the programmer and then my laptop is not responding anything. I dont know what is the problem. i am using psoc designer 5.3 and my os is windows 7 .. is the software compatible with my hardware?
please help me out of my problem.. suggest me a some solutions
Solved! Go to Solution.
You have probably mis-spelled the PWM8_1 component. Check the name in the chip-view. You shouls remove before you program your chip all errors and all warnings.
@bob, devmania mean P00 not POD.
So you have download the code, and if you are using the ICE-cube, time to debug.
How about upload with you latest code so people here can help.
Sounds like in your code sw when active grounds the pin, when
inactive then when part first starts up could reflect initial pin setting
and a combination of the fact you are not using shadow register
for that port. See ap note for discussion of shadow registers -
i again did some alter and now my switch is also working according to my program. But in the design in pinout i configure the p00 drive to pull down so what happening is after downloading my led is blinking but when i press the switch the led stop to blink. But if i change the drive to pull up then after downloading the program the led blinks once and then stops and switch also does not works for it. what could be done.
i am uploading the project , please have a look on it
I tried to open your project with Designer 5.3, 5.4, 4.4, and none of them
would open the project. Try a clean and build, then a archive from file
I can open the project with 5.4
"Normally" when one presses a button you do not process it
until it is released. And you debounce it, both becoming active
and releasing. Once released then action is taken, like test
PWM8running flag to see if it should be started or stopped.