- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
I have a problem with CY8CKIT-050 PSoC5LP. When I tried the examples with Mixer, it builds and works perfectly, until I connect the wrong ports with each other. After that, I notice the LED3 and LED4 turned on. And I can't debug anymore because of this warning. The board turns hot very quickly. I hope I didn't burn the PSoC chip already. Is there any way to reflash the board with PSoC programmer?
Any help is appreciated.
Best regards,
V
Solved! Go to Solution.
- Labels:
-
PSoC 5 Device Programming
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think you have connected the power rails wrongly and hence the LED3 and LED4 aren't turning off. Please set the jumpers appropriately to 3.3V as shown below:
You can find more information on power rails in Page#18 here: https://www.cypress.com/file/45276/download
Regards,
Dheeraj