Could someone check the attached project which is for UART Bootloader. Once the bootlodable receives the command from PC (or something trigger for reboot) , it calls Bootlodable_1_Load() to accept commands from UART bootloader host. However the bootloader does not accept anything and freezes. My development environment is PSoC Creator 3.0 SP2 and both components are 1.20. Your any advice will be appreciated. Thanks in advance, Shuichi
Thanks for your advice, all. Finally I have succeeded the bootloader runs well. I'm not sure the reason of defect exactly , but something lots of tries such as component updates or rebuilds from scratch might be effective.