Anonymous
Not applicable
Feb 06, 2018
08:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 06, 2018
08:53 AM
I'm new to Psoc and I just wanted to know if it was possible to program the Kitprog device through a Ethernet connection instead of usb. I'm using the CY8CKIT-059 PSoC 5LP.
Solved! Go to Solution.
Labels
1 Solution
Feb 06, 2018
12:03 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 06, 2018
12:03 PM
Programming the PSoC 5LP on CY8CKIT-059 through Ethernet connection is not possible.
2 Replies
Feb 06, 2018
12:03 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 06, 2018
12:03 PM
Programming the PSoC 5LP on CY8CKIT-059 through Ethernet connection is not possible.
Feb 14, 2018
01:03 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 14, 2018
01:03 PM
Is there any scenario where the chip could be programmed with a Ethernet connection, say if the chip was soldered to a board with a Ethernet port?