Jun 08, 2021
10:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 08, 2021
10:33 AM
I'm using CY8C29666 to generate two inverted PWM signals. That worked fine.
Now I want to enable and disable that PWM block using other PWM with much lower clock, like I show in the image.
I connected the enable input of my PWMDB to the output of the other PWM, but this is not working.
Previously, I've used a Counter to feed the Clock signal to an UART, so I expected this to work. Am I missing something on this? Any information would help.
Thanks
Labels
- Labels:
-
PSoC1 MCU
1 Reply
Jun 09, 2021
10:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 09, 2021
10:46 PM
Hello @suleymaniye ,
For troubleshooting this issue, can you kindly change the clock of PWMDB8_1 to VC2, and check if the PWMDB8 counts when enabled?
Best regards,
Sampath Selvaraj