- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am looking for help on programming psoc with Cypress MiniProg3, using Jtag. I am evaluating the CY8C5888LTI-LP097. I would like to find out which pins to hook up to? I also like to know what type of file to generate for JTAG programming ? Can you also look into how to incorporate a boot loader into the JTAG programming ? Which type of interface does the bootloader support? Can you specify the pin outs, and generate the loadable file for updating the application?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can look into schematics of CY8CKIT-059 which is CY8C5888LTI-LP097 based at this link-
The J5 connector on CY8CKIT-059 is available for MiniProg3 to have JTAG programming for the device.
For understanding bootloader in PSoC, you can go through this AN, which will be very helpful-
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can look into schematics of CY8CKIT-059 which is CY8C5888LTI-LP097 based at this link-
The J5 connector on CY8CKIT-059 is available for MiniProg3 to have JTAG programming for the device.
For understanding bootloader in PSoC, you can go through this AN, which will be very helpful-