PG-VQFN-68 footprint and stencil

[taas_3144281]

Hi.

My customer wants to mount the CY8C5288LTI-LP090 on a board.
So we need the footprint and stencil information.
I have found the information below.
https://www.infineon.com/cms/en/product/packages/PG-VQFN/PG-VQFN-68-801/

It says to refer to "IPC-7351. Generic Requirements for Surface Mount", is there any footprint and stencil drawing information provided by Infineon?

I'm sorry for the information of other companies, but if you have the following information, development will go smoothly.

https://ww1.microchip.com/downloads/aemDocuments/documents/corporate-responsibilty/environmental/mat...

best regards

[Gautami_12]

Hi @taas_3144281 ,

You can find the footprints for PSoC 5LP in page number 107 and 108 in the PSoC® 5LP: CY8C52LP Family Datasheet Programmable System-on-Chip (PSoC®)

Also please refer to the screenshot below:-

Warm Regards,
Gautami J

[taas_3144281]

Hi, Gautami J

Thank you for your answer.

My customer wants information on footprints and stencils to refer to when mounting on a board.
as shown below.

best regards

[Gautami_12 · Accepted solution]

Hi @taas_3144281 ,

Please refer to Board Assembly Recommendations (General) which you can also find on our Infineon website.
This has the necessary information. Please let us know if this meets your expectation.

Warm Regards.
Gautami J