- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There was an error running port acquire: Can not acquire SWD device!
My board was working. After configuring in a new PC the mini programmer is not detecting the PSOC3 BOARD.
The board is running with old programe.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @zaciitm,
Please make sure the Debug select has the SWD+SWV option selected and Enable device protection is unchecked in your project. Please refer to the screenshot.
Can you please also refer to the There was an error running port acquire: Can not acquire SWD device! thread for more information.
Warm Regards,
Gautami J
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @zaciitm,
Please make sure the Debug select has the SWD+SWV option selected and Enable device protection is unchecked in your project. Please refer to the screenshot.
Can you please also refer to the There was an error running port acquire: Can not acquire SWD device! thread for more information.
Warm Regards,
Gautami J
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for your reply.
"System setting was same as shown in your reply.
Still I couldn't find a solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
How about trying to (re) install PSoC programmer?
Download the newest PSoC Programmer from the URL below.
https://www.infineon.com/cms/en/design-support/tools/tools-archive/psoc-programmer-archive/
moto